Gunner Forum banner
1 - 5 of 5 Posts

·
Registered
Joined
·
5 Posts
Discussion Starter · #1 ·
I purchased a Crackshot 26 that was missing some parts. I replaced the extractor, firing pin, and the lever roller. The problem is it will not extract properly. A shell will move freely in and out without the extractor in place; and the extractor moves freely in and out with out the shell in the chamber. But, with the extractor in place and a shell in the chamber it will not extract. The barrel and rifling are in very good Condition.
I am new here so I don't know if I am doing this correctly. I welcome any comments or suggestions.
Kindest Regards, and a very Blessed and Merry Christmas to all,
Deadwood Pete
 
1 - 5 of 5 Posts
Top